Home › BODY ELECTRICAL › LIGHTING › LIGHTING SYSTEM

LIGHTING SYSTEM > LVL Terminal Circuit

for Preparation Click here


DESCRIPTION

  1. By connecting terminals LVL and CG of the DLC3, the headlight beam level control ECU performs the following:
    1. Initializes the height control sensor signal.
    2. Performs the operation check of the headlight leveling motor.

WIRING DIAGRAM


C112013E05


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (DLC3 - HEADLIGHT BEAM LEVEL CONTROL ECU)


    E121449E02
  1. Disconnect the A20 headlight beam level control ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    A20-5 (SPDL) - E10-8 (LVL)
    Always
    Below 1 Ω
    A20-5 (SPDL) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK HARNESS AND CONNECTOR (DLC3 - BODY GROUND)


    E106867E31
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E10-4 (CG) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE