REAR AXLE HUB AND BEARING > INSTALLATION |
| 1. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY |
![]() |
Install the hub and bearing assembly with the 4 bolts.
Connect the skid control sensor connector.
| 2. INSPECT REAR AXLE HUB BEARING LOOSENESS |
![]() |
Using a dial indicator, check for looseness near the center of the axle hub.
| 3. INSPECT REAR AXLE HUB RUNOUT |
![]() |
Using a dial indicator, check for runout on the surface of the axle hub outside the hub bolt.
| 4. INSTALL REAR DISC |
![]() |
Aligning the matchmarks, install the rear disc.
| 5. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY |
![]() |
Install the rear disc brake caliper with the 2 bolts.
![]() |
Install the rear flexible hose with the bolt.
| 6. INSTALL REAR WHEEL |
| 7. CHECK ABS SPEED SENSOR SIGNAL |
ABS: Click here
VSC: Click here