Home › SUSPENSION & AXLE › AXLE › REAR AXLE HUB AND BEARING

REAR AXLE HUB AND BEARING > INSTALLATION

for Preparation Click here



1. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY


    C083035E02
  1. Install the hub and bearing assembly with the 4 bolts.

    Torque:
    80 N*m{ 816 kgf*cm , 59 ft.*lbf }

  1. Connect the skid control sensor connector.

    NOTICE:
    Do not twist the sensor wire when connecting it.



2. INSPECT REAR AXLE HUB BEARING LOOSENESS


    C119285
  1. Using a dial indicator, check for looseness near the center of the axle hub.

    Maximum:
    0.05 mm (0.0020 in.)

    NOTICE:
    Ensure that the dial indicator is set perpendicular to the measurement surface.

    If looseness exceeds the maximum, replace the axle hub assembly.



3. INSPECT REAR AXLE HUB RUNOUT


    C119286
  1. Using a dial indicator, check for runout on the surface of the axle hub outside the hub bolt.

    Maximum:
    0.07 mm (0.0027 in.)

    NOTICE:
    Ensure that the dial indicator is set perpendicular to the measurement surface.

    If runout exceeds the maximum, replace the axle hub assembly.



4. INSTALL REAR DISC


    C132813E01
  1. Aligning the matchmarks, install the rear disc.

    HINT:
    When replacing the rear disc with a new one, select the installation position where the rear disc has the minimum runout.



5. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY


    C145052E01
  1. Install the rear disc brake caliper with the 2 bolts.

    Torque:
    62 N*m{ 630 kgf*cm , 46 ft.*lbf }

    NOTICE:
    Do not twist the brake hose when installing the rear disc brake caliper assembly LH.



    C083014E03
  1. Install the rear flexible hose with the bolt.

    Torque:
    19 N*m{ 192 kgf*cm , 14 ft.*lbf }



6. INSTALL REAR WHEEL

Torque:
103 N*m{ 1050 kgf*cm , 76 ft.*lbf }



7. CHECK ABS SPEED SENSOR SIGNAL
  1. ABS: Click here

  1. VSC: Click here