Home › SUSPENSION & AXLE › AXLE › REAR AXLE HUB AND BEARING

REAR AXLE HUB AND BEARING > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. REMOVE REAR WHEEL


2. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY


    C083014E02
  1. Remove the bolt and separate the flexible hose from the shock absorber.



    C145052E01
  1. Remove the 2 bolts and separate the rear disc brake caliper assembly.

    NOTICE:
    Use wire or an equivalent tool to keep the brake caliper from hanging down by the flexible hose.



3. REMOVE REAR DISC


    C132813E01
  1. Put matchmarks on the rear disc and the axle hub.



    C131914E02
  1. Release the parking brake and remove the rear disc.

    HINT:
    If the disc cannot be removed easily, turn and press firmly the shoe adjuster until the wheel comes free.



4. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY
  1. Disconnect the skid control sensor connector.



    C083035E01
  1. Remove the 4 bolts and hub and bearing assembly.