REAR AXLE CARRIER > INSTALLATION |
| 1. INSTALL REAR AXLE CARRIER SUB-ASSEMBLY |
![]() |
Install the rear axle carrier sub-assembly to the shock absorber with the 2 bolts and 2 nuts.
| 2. TEMPORARILY TIGHTEN REAR NO. 1 SUSPENSION ARM |
![]() |
Temporarily tighten the rear No. 1 suspension arm with the bolt and nut.
| 3. TEMPORARILY TIGHTEN REAR NO. 2 SUSPENSION ARM |
![]() |
Temporarily tighten the rear No. 2 suspension arm with the bolt and nut.
| 4. TEMPORARILY TIGHTEN REAR STRUT ROD |
Temporarily tighten the rear strut rod with the bolt and nut.
| 5. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY |
![]() |
Install the hub and bearing assembly with the 4 bolts.
Connect the skid control sensor connector.
| 6. INSPECT REAR AXLE HUB BEARING LOOSENESS |
![]() |
Using a dial indicator, check for looseness near the center of the axle hub.
| 7. INSPECT REAR AXLE HUB RUNOUT |
![]() |
Using a dial indicator, check for runout on the surface of the axle hub outside the hub bolt.
| 8. INSTALL REAR DISC |
![]() |
Aligning the matchmarks, install the rear disc.
| 9. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY |
![]() |
Install the rear disc brake caliper with the 2 bolts.
![]() |
Install the rear flexible hose with the bolt.
| 10. INSTALL REAR WHEEL |
| 11. STABILIZE SUSPENSION |
![]() |
Jack up the rear axle carrier, placing a wooden block to avoid damage. Apply load to the suspension so that the installed bolt of the rear suspension No. 1 arm (inner side of vehicle) is horizontally aligned with the center of the rear axle hub.
| 12. FULLY TIGHTEN REAR NO. 1 SUSPENSION ARM |
![]() |
Fully tighten the bolt.
| 13. FULLY TIGHTEN REAR NO. 2 SUSPENSION ARM |
![]() |
Fully tighten the bolt.
| 14. FULLY TIGHTEN REAR STRUT ROD |
![]() |
Fully tighten the bolt.
| 15. INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY RH (w/ HID Headlight System) |
| 16. ADJUST REAR WHEEL ALIGNMENT |
| 17. HEIGHT CONTROL SENSOR SIGNAL INITIALIZATION (w/ HID Headlight System) |
| 18. CHECK ABS SPEED SENSOR SIGNAL |
ABS: Click here
VSC: Click here