Home › SUSPENSION & AXLE › AXLE › REAR AXLE CARRIER

REAR AXLE CARRIER > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. REMOVE REAR WHEEL


2. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY


    C083014E02
  1. Remove the bolt and separate the flexible hose from the shock absorber.



    C145052E01
  1. Remove the 2 bolts and separate the rear disc brake caliper assembly.

    NOTICE:
    Use wire or an equivalent tool to keep the brake caliper from hanging down by the flexible hose.



3. REMOVE REAR DISC


    C132813E01
  1. Put matchmarks on the rear disc and the axle hub.



    C131914E02
  1. Release the parking brake and remove the rear disc.

    HINT:
    If the disc cannot be removed easily, turn and press firmly the shoe adjuster until the wheel comes free.



4. SEPARATE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY RH (w/ HID Headlight System)

HINT:
Perform the procedure only when removing the RH side.



5. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY
  1. Disconnect the skid control sensor connector.



    C083035E01
  1. Remove the 4 bolts and hub and bearing assembly.



6. SEPARATE REAR STRUT ROD
  1. Remove the bolt and nut, and separate the rear strut rod (rear axle carrier side) from the rear axle carrier sub-assembly.

    HINT:
    When removing the bolt, keep the nut from rotating.



7. SEPARATE REAR NO. 2 SUSPENSION ARM


    G024053
  1. Remove the bolt and nut, and separate the rear No. 2 suspension arm (rear axle carrier side) from the rear axle carrier sub-assembly.

    HINT:
    When removing the bolt, keep the nut from rotating.



8. SEPARATE REAR NO. 1 SUSPENSION ARM


    G025995
  1. Remove the bolt and nut, and separate the rear No. 1 suspension arm (rear axle carrier side) from the rear axle carrier sub-assembly.

    HINT:
    When removing the bolt, keep the nut from rotating.



9. REMOVE REAR AXLE CARRIER SUB-ASSEMBLY


    C129156
  1. Remove the 2 bolts and 2 nuts, and remove the rear axle carrier sub-assembly from the shock absorber.