Home › BRAKE › BRAKE CONTROL › ANTI-LOCK BRAKE SYSTEM

ANTI-LOCK BRAKE SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here




1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS
    1. Interview the customer to confirm the trouble.


    NEXT


    3.CHECK CAN COMMUNICATION SYSTEM
    1. Check for DTCs (Click here).

      HINT:
      The skid control ECU is connected to the CAN communication system.
      Therefore, before starting troubleshooting, make sure to check that there is no trouble in the CAN communication system.


      Result:

      Result
      Proceed to
      DTC is not output
      A
      DTC is output
      B



    B.
    CHECK CAN COMMUNICATION CIRCUIT
    A


    4.CHECK DTC AND FREEZE FRAME DATA
    1. Check for DTCs and Freeze Frame Data (Click here for DTC Check / Clear, Click here for Freeze Frame Data).

      1. Record the DTCs and Freeze Frame Data.

    2. Clear the DTCs.

    3. Recheck for DTCs.

      1. Reproduce the malfunction and check if the DTCs are output again.

        Result:

        Result
        Proceed to
        DTC is output
        A
        DTC is not output (Problem symptom does not occur)
        B
        DTC is not output (Problem symptom occurs)
        C



    B.
    GO TO STEP 9

    C.
    GO TO STEP 10
    A


    5.DIAGNOSTIC TROUBLE CODE CHART
    1. Go to "DIAGNOSTIC TROUBLE CODE CHART" (Click here).


    NEXT


    6.CIRCUIT INSPECTION

      NEXT


      7.REPAIR OR REPLACE

        NEXT


        8.CONFIRMATION TEST

          NEXT

          END


          9.SYMPTOM SIMULATION

            NEXT


            10.PROBLEM SYMPTOMS TABLE
            1. Go to "PROBLEM SYMPTOMS TABLE" (Click here).


            NEXT


            11.CIRCUIT INSPECTION

              NEXT


              12.REPAIR OR REPLACE

                NEXT


                13.CONFIRMATION TEST

                  NEXT

                  END