ANTI-LOCK BRAKE SYSTEM > DTC CHECK / CLEAR |
| DTC CHECK / CLEAR (SST CHECK WIRE) |
![]() |
DTC check
Using SST, connect terminals TC and CG of the DLC3.
Turn the ignition switch to the ON position.
Read the DTCs from the ABS warning light on the combination meter.
| Trouble Area | See procedure |
| TC and CG terminal circuit |
Click here
|
| ABS warning light circuit (Remains on) |
Click here
|
| ABS warning light circuit (Does not come on) |
Click here
|
As an example, refer to the chart below for the blinking patterns of the normal system code and trouble codes 11 and 21.

The codes are explained in the code table (Click here).
After completing the check, disconnect terminals TC and CG of the DLC3, and turn off the display. If 2 or more DTCs are detected at the same time, the DTCs will be displayed in ascending order.
![]() |
DTC clear
Using SST, connect terminals TC and CG of the DLC3.
Turn the ignition switch to the ON position.
![]() |
Clear the DTCs stored in the ECU by depressing the brake pedal 8 times or more within 5 seconds.
Check that the warning light indicates the normal system code.
Remove the SST from the terminals of the DLC3.
| DTC CHECK/CLEAR (WHEN USING INTELLIGENT TESTER:) |
![]() |
DTC check
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position.
Read the DTCs by following the prompts on the tester screen.
DTC clear
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position.
Operate the intelligent tester to clear the codes.
| END OF DTC CHECK/CLEAR |
Turn the ignition switch to the ON position.
Check that the ABS warning light goes off within approximately 3 seconds.