Home › BODY ELECTRICAL › DOOR LOCK › ELECTRICAL KEY OSCILLATOR (for Rear Side)

ELECTRICAL KEY OSCILLATOR (for Rear Side) > INSTALLATION

for Preparation Click here



1. INSTALL ELECTRICAL KEY OSCILLATOR (ELECTRICAL KEY ANTENNA)


    B223347
  1. Install the electrical key oscillator (electrical key antenna) with the 2 nuts.

    Torque:
    31 N*m{ 316 kgf*cm , 23 ft.*lbf }

  1. Connect the connector.



2. INSTALL REAR BUMPER ASSEMBLY


  1. w/ TOYOTA Parking Assist-sensor System:



      B224151
    1. Connect the connector.



    B227289
  1. Engage the 12 claws and connect the rear bumper assembly as shown in the illustration.

    HINT:
    Use the same procedure for the LH side and RH side.



    B137214
  1. Install the rear bumper assembly with the 6 screws and 2 clips.



    B137213
  1. Install the 2 rear bumper plates.



3. INSTALL REAR QUARTER PANEL MUDGUARD SUB-ASSEMBLY LH (w/ Rear Fender Mudguard)


    B137209
  1. Install the rear quarter panel mudguard sub-assembly LH with the 3 screws.



4. INSTALL REAR QUARTER PANEL MUDGUARD SUB-ASSEMBLY RH (w/ Rear Fender Mudguard)

HINT:
Use the same procedure for the RH side and LH side.