Home › BODY ELECTRICAL › DOOR LOCK › ELECTRICAL KEY OSCILLATOR (for Rear Side)

ELECTRICAL KEY OSCILLATOR (for Rear Side) > REMOVAL

for Preparation Click here



1. REMOVE REAR QUARTER PANEL MUDGUARD SUB-ASSEMBLY LH (w/ Rear Fender Mudguard)


    B137209
  1. Remove the 3 screws and rear quarter panel mudguard sub-assembly LH.



2. REMOVE REAR QUARTER PANEL MUDGUARD SUB-ASSEMBLY RH (w/ Rear Fender Mudguard)

HINT:
Use the same procedure for the RH side and LH side.



3. REMOVE REAR BUMPER ASSEMBLY


    B137211E01
  1. Put protective tape around the rear bumper assembly.



    B137212
  1. Using a screwdriver, open the 2 rear bumper plates.

    HINT:
    Tape the screwdriver tip before use.



    B137214
  1. Remove the 6 screws and 2 clips.



    B137215
  1. Disengage the 12 claws and disconnect the rear bumper assembly as shown in the illustration.

    HINT:
    Use the same procedure for the RH side and LH side.



  1. w/ TOYOTA Parking Assist-sensor System:



      B224151
    1. Disconnect the connector.

  1. Remove the rear bumper assembly.



4. REMOVE ELECTRICAL KEY OSCILLATOR (ELECTRICAL KEY ANTENNA)


    B223347
  1. Disconnect the connector.

  1. Remove the 2 nuts and electrical key oscillator (electrical key antenna).