Home › ENGINE · 2GR-FE › STARTING › ENTRY AND START SYSTEM

DTC    B2275    STSW Monitor Malfunction

for Preparation Click here


DESCRIPTION

This DTC is output when there is an open, short, or any other problem in the engine start request output circuit inside the main body ECU or in the external circuit.

HINT:
When the main body ECU is replaced with a new one and the negative (-) battery terminal is connected, the power source mode becomes the IG-ON mode. When the battery is removed and reinstalled, the power source mode that was selected when the battery was removed is restored.
After the main body ECU is replaced, perform the registration procedures for the engine immobiliser system.


DTC No.
DTC Detection Condition
Trouble Area
B2275
ST output circuit (engine starting request signal circuit) inside main body ECU or other related circuit is malfunctioning
  1. Main body ECU
  2. ECM
  3. Wire harness or connector

WIRING DIAGRAM


B226734E01


INSPECTION PROCEDURE

1.CHECK DTC OUTPUT
  1. Clear the DTCs (Click here).

    HINT:
    After all DTCs are cleared, turn the engine switch on (IG) and depress the brake pedal. After 15 seconds have elapsed, check if the trouble occurs again.

  1. Check for DTCs again.

    OK:
    DTC is not output.



NG
Go to step 2
OK

USE SIMULATION METHOD TO CHECK (Click here)  

2.CHECK WIRE HARNESS (MAIN BODY ECU - ECM)


  1. Disconnect the E9 ECU connector.


    B137996E06

  1. Disconnect the A55*1 or E24*2 ECM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E9-4 (STSW) - A55-14 (STSW)*1
    E9-4 (STSW) - A24-14 (STSW)*2
    Always
    Below 1 Ω
    E9-4 (STSW) - Body ground
    Always
    10 kΩ or higher

    1. *1: for LHD
    2. *2: for RHD



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.INSPECT MAIN BODY ECU


    B138004E01
  1. Reconnect the connectors.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    E9-4 (STSW) - Body ground
    Brake pedal depressed, Engine switch hold on (ST)
    Output voltage at terminal AM1 or AM2 is -2 V or more.



NG
REPLACE MAIN BODY ECU
OK


4.CHECK MAIN BODY ECU OPERATION
  1. After replacing the main body ECU with a normally functioning ECU, check that the engine can start.

    OK:
    Engine can start normally.



NG
GO TO ENGINE CONTROL SYSTEM
OK

END (MAIN BODY ECU WAS DEFECTIVE)