DTC B2281 "P" Signal Malfunction |
| DTC No. | DTC Detection Condition | Trouble Area |
| B2281 | Cable information and CAN information between main body ECU and shift lock control ECU are inconsistent |
|

| 1.READ VALUE USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG)..
Turn the intelligent tester on.
Enter the following menus: Body / Body / Data List.
Read the Data List according to the displays on the intelligent tester.
| Tester Display | Measurement Item/Display | Normal Condition | Diagnostic Note |
| Shift P Sig | Shift P Signal / ON or OFF | ON: Shift P signal ON (Shift position is P) OFF: Shift P signal OFF (Shift position is not P) | - |
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - SHIFT LOCK CONTROL ECU) |
Disconnect the E9 and E57 ECU connectors.

Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E9-2 (P) - E57-11 (P2) | Always | Below 1 Ω |
| E9-2 (P) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.CHECK MAIN BODY ECU OPERATION |
After replacing the main body ECU with a normally functioning ECU, check that the engine can start normally.
|
| ||||
| OK | ||
| ||