Home › BODY ELECTRICAL › LIGHTING › LIGHTING SYSTEM

LIGHTING SYSTEM > Taillight Relay Circuit

for Preparation Click here


DESCRIPTION

The main body ECU receives a signal from the headlight dimmer switch assembly, and turns the taillight relay on.

WIRING DIAGRAM


E133234E01


E121494E01


INSPECTION PROCEDURE

1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to the ON position and turn the intelligent tester main switch on.

  1. Select the item below in the ACTIVE TEST and then check that the relay operates.

    Main Body (Main Body ECU): 
    Item
    Test Details
    Diagnostic Note
    TAIL LIGHT
    Taillight relay ON / OFF
    -

    OK:
    Taillight relay operates. (Taillights illuminate.)



OK
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
NG


2.INSPECT FUSE (TAIL)
  1. Remove the TAIL fuse from the instrument panel J/B assembly.

  1. Measure the resistance of the fuse.

    Standard resistance:
    Below 1 Ω



NG
REPLACE FUSE
OK


3.INSPECT TAILLIGHT RELAY


    A087121E11
  1. Remove the taillight relay from the instrument panel J/B assembly.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    3 - 5
    10 kΩ or higher
    Below 1 Ω (When battery voltage is applied to terminals 1 and 2)
    3 - 4
    Below 1 Ω
    10 kΩ or higher (When battery voltage is applied to terminals 1 and 2)



NG
REPLACE TAILLIGHT RELAY
OK


4.INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY


    E121540E03
  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    IC-4 - Body ground
    Ignition switch ON, light control switch OFF → TAIL
    Below 1 V → 10 to 14 V
    IC-5 - Body ground
    Ignition switch ON, light control switch OFF → TAIL
    Below 1 V → 10 to 14 V
    IP-8 - Body ground
    Ignition switch ON, light control switch OFF → TAIL
    Below 1 V → 10 to 14 V



OK
REPAIR OR REPLACE HARNESS OR CONNECTOR (INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY - BODY GROUND)
NG


5.CHECK HARNESS AND CONNECTOR (BATTERY - INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY)


    E121505E01
  1. Disconnect the IA instrument panel J/B assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    IA-1 - Body ground
    Always
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY