Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR CONDITIONING SYSTEM

AIR CONDITIONING SYSTEM > LIN Communication Circuit

for Preparation Click here


DESCRIPTION

The operation signal of a switch etc. is exchanged between terminal TX+ of the A/C control assembly (heater control base sub-assembly) and terminal LIN1 of the A/C amplifier.

WIRING DIAGRAM


E208297E05


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (A/C CONTROL ASSEMBLY - AIR CONDITIONING AMPLIFIER)


    E124480E05
  1. Disconnect the connector from the A/C control assembly (heater control base sub-assembly).



    E124470E17
  1. Disconnect the connector from the A/C amplifier.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection (Symbols)
    Condition
    Specified Condition
    E38-37 (LIN1) - F16-4 (TX+)
    Always
    Below 1 Ω
    E38-37 (LIN1) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE