FRONT SEAT ASSEMBLY (for Manual Seat) > REASSEMBLY |
| 1. INSTALL SEAT POSITION SENSOR (for Driver Side) |
Check that the ignition switch is off.
Check that the negative battery (-) cable is disconnected.
![]() |
Engage the pin and install the seat position sensor to the seat slide position sensor protector as shown in the illustration.
![]() |
Using a feeler gauge 1.0 mm (0.039 in.), temporarily install the seat position sensor.
![]() |
Using a "TORX" socket (T30), tighten the "TORX" screw to install the seat position sensor.
Make sure that a clearance between the seat position sensor and the seat rail is within 0.6 mm (0.024 in.) to 1.4 mm (0.055 in.).
Check that there is no looseness in the installation parts of the seat position sensor.
Connect the connector.
| 2. INSTALL FRONT LOWER SEAT CUSHION SHIELD LH |
| 3. INSTALL FRONT LOWER SEAT CUSHION SHIELD RH |
| 4. INSTALL RECLINING ADJUSTER INSIDE COVER LH |
| 5. INSTALL RECLINING ADJUSTER INSIDE COVER RH |
| 6. INSTALL RECLINING ADJUSTER INSIDE COVER LH |
| 7. INSTALL RECLINING ADJUSTER INSIDE COVER RH |
| 8. INSTALL FRONT SEAT SIDE AIRBAG ASSEMBLY |
![]() |
Install the front seat side airbag assembly with 2 new nuts.
Engage the 2 clamps to connect the wire harness.
![]() |
Engage the 5 clamps to connect the wire harness.
| 9. INSTALL FRONT SEPARATE TYPE SEATBACK COVER |
![]() |
Using hog ring pliers, install the front separate type seatback cover to the front separate type seatback pad with 10 new hog rings.
| 10. INSTALL FRONT SEPARATE TYPE SEATBACK COVER WITH PAD |
![]() |
Fully cover the airbag with the 2 seatback cover brackets and tighten the nut.
![]() |
Using hog ring pliers, install the front separate type seatback cover with pad to the seat frame with 2 new hog rings, and attach the hooks.
![]() |
Engage the 3 hooks.
| 11. INSTALL FRONT SEAT HEADREST SUPPORT |
| 12. INSTALL FRONT SEAT HEADREST SUPPORT |
| 13. INSTALL FRONT SEATBACK BOARD SUB-ASSEMBLY |
| 14. INSTALL FRONT SEPARATE TYPE SEAT CUSHION COVER |
![]() |
Using hog ring pliers, install the front separate type seat cushion cover to the front separate type seat cushion pad with 16 new hog rings.
| 15. INSTALL FRONT SEPARATE TYPE SEAT CUSHION COVER WITH PAD |
| 16. INSTALL FRONT INNER SEAT CUSHION SHIELD |
| 17. INSTALL FRONT SEAT INNER BELT ASSEMBLY |
![]() |
Install the front seat inner belt assembly with the nut.
![]() |
for Driver seat:
Connect the connectors and engage the 4 clamps.
for Passenger seat:
Connect the connector and engage the 3 clamps.
| 18. INSTALL LOWER SEAT TRACK SPACER |
| 19. INSTALL FRONT SEAT CUSHION SHIELD (for Driver Seat) |
| 20. INSTALL RECLINING ADJUSTER RELEASE HANDLE |
| 21. INSTALL VERTICAL ADJUSTING HANDLE NO. 2 (for Driver Seat) |
| 22. INSTALL VERTICAL ADJUSTER COVER LH (for Driver Seat) |