FRONT SEAT SIDE AIRBAG ASSEMBLY (for Manual Seat) > INSTALLATION |
| 1. INSTALL FRONT SEAT SIDE AIRBAG ASSEMBLY |
![]() |
Install the front seat side airbag assembly with 2 new nuts.
Engage the 2 clamps to connect the wire harness.
![]() |
Engage the 5 clamps to connect the wire harness.
| 2. INSTALL FRONT SEATBACK COVER WITH PAD |
![]() |
Fully cover the airbag with the 2 seatback cover brackets and tighten the nut.
![]() |
Using hog ring pliers, install the front separate type seatback cover with pad to the seat frame with 2 new hog rings, and attach the hooks.
![]() |
Engage the 3 hooks.
| 3. INSTALL FRONT SEAT HEADREST SUPPORT (for LH Side) |
| 4. INSTALL FRONT SEAT HEADREST SUPPORT (for RH Side) |
| 5. INSTALL FRONT SEAT BACK BOARD SUB-ASSEMBLY |
| 6. INSTALL FRONT INNER SEAT CUSHION SHIELD |
| 7. INSTALL FRONT SEAT INNER BELT ASSEMBLY |
![]() |
Install the front seat inner belt assembly with the nut.
![]() |
for Driver seat:
Connect the connectors and engage the 4 clamps.
for Passenger seat:
Connect the connector and engage the 3 clamps.
| 8. INSTALL FRONT SEAT CUSHION SHIELD |
| 9. INSTALL RECLINING ADJUSTER RELEASE HANDLE |
| 10. INSTALL VERTICAL ADJUSTING HANDLE NO. 2 (for Driver Seat) |
| 11. INSTALL VERTICAL ADJUSTER COVER LH (for Driver Seat) |
| 12. INSTALL FRONT SEAT ASSEMBLY |
Place the front seat assembly in the vehicle and align the adjuster pin with the hole on the vehicle side.
Connect the connector and clamp.
Move the front seat assembly to the rearmost position by operating the slide handle.
![]() |
Temporarily install the front seat track bracket with the 2 bolts.
Move the front seat assembly fully forward by operating the slide handle.
![]() |
Temporarily install the rear seat track bracket with the 2 bolts.
Move the front seat assembly to the rearmost position by operating the slide handle.
Fully tighten the 2 bolts on the front seat track bracket in the order of the inner side bolt and then the outer side bolt.
Move the front seat assembly fully forward by operating the slide handle.
Fully tighten the 2 bolts on the rear seat track bracket in the order of the inner side bolt and then the outer side bolt.
| 13. INSTALL INNER SEAT TRACK BRACKET COVER |
![]() |
Slide the inner seat track bracket cover along the seat rail toward the front of the vehicle. Engage claw A to the seat rail.
Push the seat track bracket cover inner to engage claw B.
| 14. INSTALL SEAT TRACK COVER |
![]() |
Slide the seat track cover along the seat rail toward the front of the vehicle. Engage claw A to the seat rail.
Push the seat track cover to engage claw B.
| 15. INSTALL FRONT SEAT HEADREST ASSEMBLY |
| 16. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 17. INSPECT SLIDE ADJUSTER LOCK |
| 18. INSPECT SRS WARNING LIGHT |