Home › ENGINE · 2GR-FE › EMISSION CONTROL › VACUUM SWITCHING VALVE (for EVAP)

VACUUM SWITCHING VALVE (for EVAP) > INSPECTION

for Preparation Click here



1. INSPECT EVAP VSV


    A124791E02
  1. Check the VSV for an open circuit.

    1. Measure the resistance.

      Standard resistance:
      Tester Connection
      Specified Condition
      1 - 2
      23 to 26 Ω at 20°C (68°F)
      1 - Body ground
      2 - Body ground
      10 kΩ or higher

      If the resistance is not as specified, replace the VSV assembly.



  1. Check VSV operation.



      A124792E01
    1. Check that air does not flow from port E to port F.



    2. A124793E01
    3. Apply battery positive voltage across the terminals.

    4. Check that air flows from port E to port F.
      If the result is not as specified, replace the VSV assembly.