Home › ENGINE ยท 2GR-FE › EMISSION CONTROL › HEATED OXYGEN SENSOR

HEATED OXYGEN SENSOR > REMOVAL

for Preparation Click here



1. REMOVE ENGINE UNDER COVER LH


2. REMOVE ENGINE UNDER COVER RH


3. REMOVE FRONT EXHAUST PIPE ASSEMBLY
  1. Disconnect the 2 heated oxygen sensor (bank 1, 2 sensor 2) connectors.



  1. Remove the 2 nuts from the exhaust front pipe (left bank exhaust manifold side).


    A135720

  1. Remove the 2 nuts from the exhaust front pipe (right bank exhaust pipe manifold side).

  1. Remove the exhaust front pipe.

  1. Remove the 2 gaskets from the exhaust front pipe.



4. REMOVE HEATED OXYGEN SENSOR (for Bank 1)


    A135716E01
  1. Using SST, remove the oxygen sensor.

    SST
    09224-00010  



5. REMOVE HEATED OXYGEN SENSOR (for Bank 2)


    A135724E01
  1. Using SST, remove the oxygen sensor.

    SST
    09224-00010