Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › COMPRESSOR AND MAGNETIC CLUTCH (for 2GR-FE)

COMPRESSOR AND MAGNETIC CLUTCH (for 2GR-FE) > DISASSEMBLY

for Preparation Click here



1. REMOVE MAGNETIC CLUTCH ASSEMBLY


    E075074
  1. Place the compressor and magnetic clutch in a vise.

  1. Using locking pliers, hold the magnetic clutch hub.

  1. Remove the bolt, magnetic clutch hub, and magnetic clutch washers.

    HINT:
    There is no set number of magnetic clutch washers because they are used for adjustment.



    E037091
  1. Using a snap ring expander, remove the snap ring and then remove the magnetic clutch rotor.

    NOTICE:
    Take care not to damage the seal cover of the bearing when removing the snap ring.

  1. Disconnect the connector.

  1. Remove the screw.



    I030400
  1. Using a snap ring expander, remove the snap ring and magnetic clutch stator.