Home › RESTRAINTS › SEAT BELT › CHILD RESTRAINT SEAT ANCHOR BRACKET

CHILD RESTRAINT SEAT ANCHOR BRACKET > REMOVAL

for Preparation Click here



1. REMOVE REAR SEAT CUSHION ASSEMBLY


    B134699E01
  1. Detach the 2 front hooks of the seat cushion from the vehicle body.

    NOTICE:
    Follow the instructions below carefully as the cushion frame can be deformed easily.


    1. Choose a hook to detach first. Place your hands near the hook as shown in the illustration. Then lift the seat cushion to detach the hook.

    2. Repeat the step above for the other hook.

  1. Remove the seat cushion.



2. REMOVE REAR SEAT HEADREST ASSEMBLY


3. REMOVE SEPARATE TYPE REAR SEATBACK ASSEMBLY (for Fold Down Seat Type)


    B136539
  1. Remove the 2 bolts and separate type rear seatback assembly LH.



4. REMOVE REAR SEATBACK COVER (for Reclining Seat Type)


    B139075
  1. Using a screwdriver, detach the claws and remove the 2 rear seatback covers.

    NOTICE:
    1. Tape the screwdriver tip before use.
    2. Use the same procedures for the RH side and LH side.



5. REMOVE SEPARATE TYPE REAR SEATBACK ASSEMBLY (for Reclining Seat Type)


    B139076E01
  1. Separate the 2 rear seat belts.



    B139081E01
  1. Disengage the 3 clamps and then separate the cover.



    B139077
  1. Remove the 2 bolts and 2 nuts and separate type rear seatback assembly LH.



6. REMOVE CHILD RESTRAINT SEAT ANCHOR BRACKET SUB-ASSEMBLY


    B132028
  1. Remove the 2 nuts and child restraint seat anchor bracket sub-assembly.