Home › RESTRAINTS › SEAT BELT › FRONT SEAT OUTER BELT ASSEMBLY

FRONT SEAT OUTER BELT ASSEMBLY > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait for 90 seconds after disconnecting the cable to prevent airbag deployment (Click here).

NOTICE:
After the ignition switch is turned off, the navigation receiver assembly (HDD navigation system) records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal.



2. REMOVE LAP BELT OUTER ANCHOR COVER


    B131995
  1. Disengage the 3 claws and remove the lap belt outer anchor cover.



3. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY


    B131996
  1. Remove the bolt and disconnect the floor end of the front seat outer belt assembly.



4. REMOVE FRONT DOOR SCUFF PLATE


    B132067
  1. Disengage the 7 claws and 3 clips, and remove the front door scuff plate LH.



5. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP


6. REMOVE REAR DOOR SCUFF PLATE


    B132068
  1. Disengage the 5 claws and 2 clips, and remove the rear door scuff plate LH.



7. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP


8. REMOVE LOWER CENTER PILLAR GARNISH


    B132057
  1. Disengage the 2 claws and 2 clips, and remove the lower center pillar garnish LH.



9. REMOVE UPPER CENTER PILLAR GARNISH


    B132059
  1. Remove the bolt.

  1. Disengage the clip and remove the upper center pillar garnish LH.



10. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY


    B131997
  1. Remove the nut and disconnect the shoulder anchor of the front seat outer belt assembly.



11. REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY


    B132001
  1. Remove the 2 bolts and the front shoulder belt anchor adjuster assembly.



12. REMOVE FRONT SEAT OUTER BELT ASSEMBLY


    B132002
  1. Using a screwdriver, pull out the locking button in the direction shown by the arrow to release the lock, and disconnect the connector as shown in the illustration.

    HINT:
    Tape the screwdriver tip before use.



    B131998
  1. Remove the 2 bolts and the front seat outer belt assembly.