Home › BODY ELECTRICAL › DOOR LOCK › DOOR CONTROL SWITCH

DOOR CONTROL SWITCH > REMOVAL

for Preparation Click here



1. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH


    B132833
  1. Disengage the 2 clips and remove the front door lower frame bracket garnish.



2. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG


    B132834E01
  1. Using a screwdriver with the tip wrapped with protective tape, disengage the 3 claws, and remove the front door inside handle bezel plug.



3. REMOVE ASSIST GRIP COVER


    B132836E01
  1. Using a screwdriver with the tip wrapped with protective tape, disengage the 6 claws and remove the assist grip cover.



4. REMOVE COURTESY LIGHT ASSEMBLY


    B132838E01
  1. Using a screwdriver with the tip wrapped with protective tape, disengage the claw and remove the courtesy light assembly.

  1. Disconnect the connector.



5. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY


    B132840E01
  1. Remove the 3 screws and clip (A).

  1. Using a clip remover, disengage the 9 clips.



    B136401E01
  1. Pull up the front door trim board in the direction indicated by the arrow.

  1. Disengage the reference bosses from the front door panel.

  1. Raise the front door trim board to disengage the 4 claws and remove the front door trim board together with the front door inner glass weatherstrip.



    B136403
  1. Disengage the 2 claws and disconnect the front door inside handle sub-assembly.



6. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY


    B136405
  1. Disconnect the connector.

  1. Remove the 3 screws and the power window regulator master switch assembly.