Home › BODY ELECTRICAL › DOOR LOCK › KEY REMINDER WARNING SYSTEM

KEY REMINDER WARNING SYSTEM > Door Courtesy Switch Circuit

for Preparation Click here


DESCRIPTION

The main body ECU detects the condition of the front door courtesy light switch assembly (driver's side).

WIRING DIAGRAM


B128328E05


B128328E06


INSPECTION PROCEDURE

1.READ VALUE USING INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to the ON position and turn the intelligent tester main switch on.

  1. Select D Door Courtesy SW in the DATA LIST and read the value displayed on the tester.

    BODY: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    D Door Courtesy SW
    Driver's side door courtesy switch signal/ON or OFF
    ON: Driver's side door is open
    OFF: Driver's side door is closed
    -

    OK:
    ON (Driver's door is open) appears on the screen.



OK
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
NG


2.INSPECT FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY


    B111600E02
  1. Remove the driver's side front door courtesy light switch (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - Switch body
    Courtesy switch pushed (Door closed)
    10 kΩ or higher
    Courtesy switch free (Door open)
    Below 1 Ω



NG
REPLACE FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY
OK


3.CHECK HARNESS AND CONNECTOR (FRONT DOOR COURTESY LIGHT SWITCH - MAIN BODY ECU)


    B139169E04
  1. Disconnect the E7 ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    LHD:
    Tester Connection
    Condition
    Specified Condition
    N6-1 - E7-24 (DCTY)
    Always
    Below 1 Ω
    N6-1 - Body ground
    10 kΩ or higher
    RHD:
    Tester Connection
    Condition
    Specified Condition
    O6-1 - E7-24 (DCTY)
    Always
    Below 1 Ω
    O6-1 - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE