WIPER SWITCH > INSPECTION |
| 1. INSPECT WINDSHIELD WIPER SWITCH ASSEMBLY |

Check the front wiper switch.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Connection | Specified Condition |
| E20-3 (+1) - E20-2 (+B) | MIST | Below 1 Ω |
| LO | ||
| E20-3 (+1) - E20-1 (+S) | OFF | |
| E20-9 (AUTO) - E20-10 (E) | AUTO | |
| E20-2 (+B) - E20-4 (+2) | HI |
| Tester Connection | Switch Condition | Specified Condition |
| E20-2 (+1) - E20-3 (+B) | MIST | Below 1 Ω |
| LO | ||
| E20-2 (+1) - E20-4 (+S) | OFF | |
| E20-6 (AUTO) - E20-5 (E) | AUTO | |
| E20-3 (+B) - E20-5 (E) | HI |
| Tester Connection | Switch Condition | Specified Condition |
| E19-2 (EW) - E19-3 (WF) | ON | Below 1 Ω |
| OFF | 10 kΩ or higher |
| Tester Connection | Switch Condition | Specified Condition |
| E19-1 (WF) - E19-2 (EW) | ON | Below 1 Ω |
| OFF | 10 kΩ or higher |
| Tester Connection | Switch Condition | Specified Condition |
| E20-7 (VR1) - E20-8 (VR2) | Adjusting ring changed from (+) side to (-) side | 0 to 2.7 kΩ |
| Tester Connection | Switch Condition | Specified Condition |
| E20-7 (VR2) - E20-8 (VR1) | Adjusting ring changed from (+) side to (-) side | 0 to 2.7 kΩ |
Check the front washer operation.
Turn the wiper switch OFF.
Connect the battery's positive (+) lead to terminal E20-2 (+B) and the negative (-) lead to terminals E20-4 (+S) and E19-2 (EW).
Connect the volt meter's positive (+) lead to E20-3 (+1) and the negative (-) lead to terminal E19-2(EW).
Turn the washer switch ON and OFF, and check the voltage between terminals E20-3 (+1) and E19-2 (EW).
