THEFT DETERRENT SYSTEM (w/ Entry and Start System) > TERMINALS OF ECU |
| CHECK MAIN BODY ECU (INSTRUMENT PANEL J/B) |
Disconnect the main body ECU (instrument panel J/B) connectors.

Measure the resistance and voltage between each terminal of the wire harness side connectors and body ground.
| Tester Connection | Wiring Color | Terminal Description | Condition | Specified Condition |
| E6-5 (RCTY) - Body ground | GR - Body ground | Rear courtesy light switch RH input | Rear door RH CLOSED (OFF) → OPEN (ON) | 10 kΩ or higher → Below 1 Ω |
| E6-21 (PCTY) - Body ground | Y - Body ground*1 L - Body ground*2 | Passenger side courtesy light switch input | Passenger side door CLOSED (OFF) → OPEN (ON) | 10 kΩ or higher → Below 1 Ω |
| E6-25 (LGCY) - Body ground | W - Body ground | Luggage compartment door courtesy light switch input | Luggage compartment door CLOSED (OFF) → OPEN (ON) | 10 kΩ or higher → Below 1 Ω |
| E7-24 (DCTY) - Body ground | L - Body ground*1 Y - Body ground*2 | Driver side door courtesy light switch input | Driver side door CLOSED (OFF) → OPEN (ON) | 10 kΩ or higher → Below 1 Ω |
| IA-1 (ACC) - Body ground | B - Body ground | Ignition power supply (ACC signal) | Engine switch on (ACC) → off | 11 to 14 V → Below 1 V |
| IA-1 (IG) - Body ground | B - Body ground | Ignition power supply (IG signal) | Engine switch on (IG) → off | 11 to 14 V → Below 1 V |
| IA-1 (BATB) - Body ground | B - Body ground | +B (power battery system) power supply | Always | 11 to 14 V |
| ID-16 (ALTB) - Body ground | W - Body ground | +B (power system alternator system) power supply | Always | 11 to 14 V |
| IF-10 (GND1) - Body ground | W-B - Body ground | Ground | Always | Below 1 Ω |
| IM-9 (GND2) - Body ground | W-B - Body ground | Ground | Always | Below 1 Ω |
| IO-7 (LCTY) - Body ground | LG - Body ground | Rear courtesy light switch LH input | Rear door LH CLOSED (OFF) → OPEN (ON) | 10 kΩ or higher → Below 1 Ω |
Reconnect the main body ECU (instrument panel J/B) connectors.
Measure the voltage between each terminal of the connectors and body ground.
| Tester Connection | Wiring Color | Terminal Description | Condition | Specified Condition |
| E8-4 (HAZ) - Body ground | W - Body ground | Turn signal flasher relay signal | System is in alarm sounding state | Below 1 V |
| ID-11 (HORN) - Body ground | B - Body ground | Vehicle horn drive | Vehicle horn is sounding (Theft deterrent system is in alarm sounding state) | Pulse generation (0 V ← → 12 V) |
| CHECK CERTIFICATION ECU ASSEMBLY (SMART KEY ECU ASSEMBLY) |
Disconnect the E74 and E75 ECU connectors.

Measure the voltage and resistance of the wire harness side connectors.
| Tester Connection | Wiring Color | Terminal Description | Condition | Specified Condition |
| E74-1 (+B) - E74-17 (E) | W - W-B | Battery power supply | Always | 11 to 14 V |
| E74-17 (E) - Body ground | W-B - Body ground | Ground | Always | Below 1 Ω |
| E75-24 (HSW) - Body ground | R - Body ground | Engine hood courtesy switch | Engine hood OPEN (OFF) → CLOSED (ON) | 10 kΩ or higher → Below 1 Ω |
Reconnect the E74 and E75 ECU connectors.
Measure the voltage of the connectors.
| Tester Connection | Wiring Color | Terminal Description | Condition | Specified Condition |
| E74-2 (IND) - Body ground | Y - Body ground | Security indicator output | Security indicator is on (It comes on only in arming preparation state or alarm sounding state. It flashes when immobiliser is operating.) | 3 to 6 V |
| E75-20 (SH) - Body ground | P - Body ground | Security horn drive | Security horn is sounding (Theft deterrent system is in alarm sounding state) | Pulse generation (0 V ← → 12 V) |