WIRELESS DOOR LOCK CONTROL SYSTEM (w/o Entry and Start System) > DIAGNOSIS SYSTEM |
| DESCRIPTION |
| CHECK DLC3 |
![]() |
The main body ECU uses ISO 157654-4 for communication protocol. The terminal arrangement of the DLC3 complies with ISO 15031-3 and matches the ISO 157654-4 format.
| Symbols (Terminal No.) | Terminal Description | Condition | Specified condition |
| SIL (7) - SG (5) | Bus "+" line | During transmission | Pulse generation |
| CG (4) - Body ground | Chassis ground | Always | Below 1 Ω |
| SG (5) - Body ground | Signal ground | Always | Below 1 Ω |
| BAT (16) - Body ground | Battery positive | Always | 11 to 14 V |
| CANH (6) - CANL (14) | HIGH-level CAN bus line | Ignition switch OFF*
| 54 to 69 Ω |
| CANH (6) - CG (4) | HIGH-level CAN bus line | Ignition switch OFF*
| 1 kΩ or higher |
| CANL (14) - CG (4) | HIGH-level CAN bus line | Ignition switch OFF*
| 1 kΩ or higher |
| CANH (6) - BAT (16) | LOW-level CAN bus line | Ignition switch OFF*
| 1 MΩ or higher |
| CANL (14) - BAT (16) | LOW-level CAN bus line | Ignition switch OFF*
| 1 MΩ or higher |
![]() |
Connect the cable of the intelligent tester to the DLC3, turn the ignition switch to the ON position and attempt to use the intelligent tester. If the screen displays a communication error message, a problem exists in the vehicle or in the tester.