THEFT DETERRENT SYSTEM (w/o Entry and Start System) > DIAGNOSIS SYSTEM |
| CHECK DLC3 |
![]() |
The main body ECU uses ISO 15765-4 for communication protocol. The terminal arrangement of the DLC3 complies with ISO 15031-3 and matches the ISO 15765-4 format.
| Symbols (Terminal No.) | Terminal Description | Condition | Specified condition |
| SIL (7) - SG (5) | Bus "+" line | During transmission | Pulse generation |
| CG (4) - Body ground | Chassis ground | Always | Below 1 Ω |
| SG (5) - Body ground | Signal ground | Always | Below 1 Ω |
| BAT (16) - Body ground | Battery positive | Always | 11 to 14 V |
| CANH (6) - CANL (14) | HIGH-level CAN bus line | Ignition switch OFF*
| 54 to 69 Ω |
| CANH (6) - CG (4) | HIGH-level CAN bus line | Ignition switch OFF*
| 1 kΩ or higher |
| CANL (14) - CG (4) | HIGH-level CAN bus line | Ignition switch OFF*
| 1 kΩ or higher |
| CANH (6) - BAT (16) | LOW-level CAN bus line | Ignition switch OFF*
| 1 MΩ or higher |
| CANL (14) - BAT (16) | LOW-level CAN bus line | Ignition switch OFF*
| 1 MΩ or higher |
![]() |
Connect the cable of the intelligent tester (with CAN VIM) to the DLC3, turn the ignition switch to the ON position and attempt to use the intelligent tester. If the screen displays a communication error message, a problem exists in the vehicle or in the tester.