Home › SECURITIES › THEFT DETERRENT › THEFT DETERRENT SYSTEM (w/o Entry and Start System)

THEFT DETERRENT SYSTEM (w/o Entry and Start System) > Engine Hood Courtesy Switch Circuit


DESCRIPTION

The engine hood courtesy switch is installed together with the hood lock. This switch turns off when the engine hood is opened and turns on when the engine hood is closed.

WIRING DIAGRAM


B144365E01


INSPECTION PROCEDURE

1.INSPECT ENGINE HOOD COURTESY SWITCH


    B144360E01
  1. Remove the courtesy switch from the hood lock.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Switch Position
    Specified Condition
    1 - 2
    Free (ON)
    Below 1 Ω
    Pushed (OFF)
    10 kΩ or higher



NG
REPLACE HOOD LOCK ASSEMBLY
OK


2.CHECK HARNESS AND CONNECTOR (ENGINE HOOD COURTESY SWITCH - BODY GROUND)


    B144361E01
  1. Disconnect the A5 switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    A5-1 - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - ENGINE HOOD COURTESY SWITCH)


    B144366E01
  1. Disconnect the E7 ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    (Symbol) Tester Connection
    Specified Condition
    HCTY (E7-16) - (A5-2)
    Below 1 Ω
    HCTY (E7-16) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE