THEFT DETERRENT SYSTEM (w/ Entry and Start System) > Security Indicator Light Circuit |

| 1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Press the intelligent tester main switch on.
Select the item below in the Active Test and then check that the indicator operates.
| Tester Display | Test Details | Diagnostic Note |
| Security Indicator | Security Indicator ON/OFF | - |
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (CLOCK ASSEMBLY - CERTIFICATION ECU) |
![]() |
Disconnect the E74 ECU connector.
Disconnect the F3 clock connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E74-2 (IND) - F3-8 (LP) | Always | Below 1 Ω |
| E74-2 (IND) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (CLOCK ASSEMBLY - BODY GROUND) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| F3-19 (GND1) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 4.INSPECT CLOCK ASSEMBLY |
![]() |
Reconnect the F3 clock connector.
Apply battery voltage between the terminals of the indicator, and check the lighting condition of the security indicator.
| Measurement Condition | Specified Condition |
| Battery positive (+) → Terminal F3-8 (LP) Battery negative (-) → Terminal F3-19 (GND1) | Security indicator comes on |
|
| ||||
| OK | ||
| ||