ULTRASONIC SENSOR (for Rear Side) > INSTALLATION |
| 1. INSTALL NO. 1 ULTRASONIC SENSOR |
![]() |
Engage the 2 claws and install the No. 1 ultrasonic sensor.
![]() |
Connect the connector.
| 2. INSTALL NO. 2 ULTRASONIC SENSOR |
![]() |
Install the No. 2 ultrasonic sensor as shown in the illustration.
![]() |
Install the sensor retainer as shown in the illustration.
![]() |
Connect the connector.
| 3. INSTALL REAR BUMPER ASSEMBLY |
![]() |
Engage the grommet.
Connect the connector.
Engage each claw.
![]() |
Install the rear bumper assembly with the 6 screws and 2 clips.
![]() |
Install the 2 rear bumper plates.
| 4. INSTALL REAR QUARTER PANEL MUDGUARD SUB-ASSEMBLY LH |
![]() |
Install the rear quarter panel mudguard sub-assembly LH with the 3 screws.
| 5. INSTALL REAR QUARTER PANEL MUDGUARD SUB-ASSEMBLY RH |
| 6. INSTALL LUGGAGE COMPARTMENT INNER TRIM COVER LH |
![]() |
Install the luggage compartment inner trim cover LH with the 2 clips.
| 7. INSTALL REAR FLOOR FINISH PLATE |
![]() |
Engage the 7 clips and install the rear floor finish plate.
| 8. INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK |
![]() |
Install the 2 No. 1 luggage compartment trim hooks with the 2 screws.
| 9. INSTALL LUGGAGE COMPARTMENT SIDE TRAY ASSEMBLY |
![]() |
Engage the clip and install the luggage compartment side tray assembly.
Install the bolt.
| 10. INSTALL SPARE WHEEL COVER ASSEMBLY |
| 11. INSTALL SPARE WHEEL COVER CLAMP |
| 12. INSTALL LUGGAGE COMPARTMENT FLOOR MAT |