Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › ULTRASONIC SENSOR (for Rear Side)

ULTRASONIC SENSOR (for Rear Side) > INSTALLATION

for Preparation Click here



1. INSTALL NO. 1 ULTRASONIC SENSOR RETAINER (for Corner Sensor)


    E135552E01
  1. Install the No. 1 ultrasonic sensor retainer to the rear bumper.

    NOTICE:
    Do not damage the bumper with the snap when installing the retainer.

    HINT:
    1. When installing the retainer, align the keyhole and snap as shown in the illustration.
    2. The illustration is for the LH side. The RH side is the opposite of the LH side.



2. INSTALL NO. 1 ULTRASONIC SENSOR (for Corner Sensor)


    E135368
  1. Engage the 2 claws and install the No. 1 ultrasonic sensor.

    HINT:
    The illustration is for the LH side. The RH side is the opposite of the LH side.

  1. Connect the sensor connector.



3. INSTALL NO. 1 ULTRASONIC SENSOR RETAINER (for Back Sensor)


    E135552E01
  1. Install the No. 1 ultrasonic sensor retainer to the rear bumper.

    NOTICE:
    Do not damage the bumper with the snap when installing the retainer.

    HINT:
    When installing the retainer, align the keyhole and snap as shown in the illustration.



4. INSTALL NO. 1 ULTRASONIC SENSOR (for Back Sensor)


    E135368
  1. Engage the 2 claws and install the No. 1 ultrasonic sensor.



    E135370
  1. Install the sensor clip as shown in the illustration.

  1. Connect the sensor connector.



5. INSTALL REAR BUMPER ASSEMBLY


  1. w/ TOYOTA Parking Assist-sensor System:



      B224151
    1. Connect the connector.



    B227289
  1. Engage the 12 claws and connect the rear bumper assembly as shown in the illustration.

    HINT:
    Use the same procedure for the LH side and RH side.



    B137214
  1. Install the rear bumper assembly with the 6 screws and 2 clips.



    B137213
  1. Install the 2 rear bumper plates.



6. INSTALL REAR QUARTER PANEL MUDGUARD SUB-ASSEMBLY LH


    B137209
  1. Install the rear quarter panel mudguard sub-assembly LH with the 3 screws.



7. INSTALL REAR QUARTER PANEL MUDGUARD SUB-ASSEMBLY RH

HINT:
Use the same procedure for the RH side and LH side.