Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › ULTRASONIC SENSOR (for Rear Side)

ULTRASONIC SENSOR (for Rear Side) > REMOVAL

for Preparation Click here



1. REMOVE LUGGAGE COMPARTMENT FLOOR MAT


2. REMOVE SPARE WHEEL COVER CLAMP


3. REMOVE SPARE WHEEL COVER ASSEMBLY


4. REMOVE LUGGAGE COMPARTMENT SIDE TRAY ASSEMBLY


    B136853
  1. Remove the bolt.

  1. Disengage the clip and remove the luggage compartment side tray assembly.



5. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK


    B136879
  1. Remove the 2 screws and the 2 No. 1 luggage compartment trim hooks.



6. REMOVE REAR FLOOR FINISH PLATE


    B136852
  1. Disengage the 7 clips and remove the rear floor finish plate.



7. REMOVE LUGGAGE COMPARTMENT INNER TRIM COVER LH


    B136854
  1. Remove the 2 clips and the luggage compartment inner trim cover LH.



8. REMOVE REAR QUARTER PANEL MUDGUARD SUB-ASSEMBLY LH


    B137209
  1. Remove the 3 screws and rear quarter panel mudguard sub-assembly LH.



9. REMOVE REAR QUARTER PANEL MUDGUARD SUB-ASSEMBLY RH

HINT:
Use the same procedure for the RH side and the LH side.



10. REMOVE REAR BUMPER ASSEMBLY


    B137211E01
  1. Put protective tape around the rear bumper assembly.



    B137212
  1. Using a screwdriver, open the 2 rear bumper plates.

    HINT:
    Tape the screwdriver tip before use.



    B137214
  1. Remove the 6 screws and 2 clips.



    B189095
  1. Disconnect the connector.

  1. Disengage the grommet.



    B137215
  1. Disengage the 12 claws and disconnect the rear bumper assembly as shown in the illustration.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Remove the rear bumper assembly.



11. REMOVE NO. 2 ULTRASONIC SENSOR


    E163888
  1. Disconnect the connector.



    E163889
  1. Remove the sensor retainer as shown in the illustration.



    E163890
  1. Remove the No. 2 ultrasonic sensor as shown in the illustration.



12. REMOVE NO. 1 ULTRASONIC SENSOR


    E163892
  1. Disconnect the connector.



    E163893
  1. Disengage the 2 claws and remove the No. 1 ultrasonic sensor.