Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › ULTRASONIC SENSOR (for Front Side)

ULTRASONIC SENSOR (for Front Side) > REMOVAL

for Preparation Click here



1. REMOVE COOL AIR INTAKE DUCT SEAL (for 2GR-FE)


    B138886
  1. Remove the 7 clips and cool air intake duct seal.



2. REMOVE FRONT BUMPER ASSEMBLY


    B220943E01
  1. Put protective tape around the front bumper assembly.



    B138884E01
  1. Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.

    HINT:
    Use the same procedure for the RH side and LH side.



    B220944
  1. Remove the 8 screws, 2 clips, 2 radiator grille protectors and bolt.



    B220945
  1. Disengage the 2 claws and disconnect the front bumper assembly as shown in the illustration.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Disconnect each connector.

  1. w/ TOYOTA Parking Assist-sensor System:

    1. Disengage the clamp and disconnect the No. 1 ultrasonic sensor connector.

  1. w/ Headlight Cleaner System:

    1. Disconnect the headlight cleaner washer hose.



    B137737
  1. Remove the front bumper assembly.



3. REMOVE NO. 1 ULTRASONIC SENSOR
  1. Disconnect the sensor connector.



    E134853
  1. While pushing down on the lever with a finger to release the claw, disengage the claw on the other side to remove the No. 1 ultrasonic sensor.

    HINT:
    1. The type of the claw on the top and bottom of the sensor are different. Observe the claws carefully before attempting to remove the sensor.
    2. The illustration is for the LH side. The RH side is the opposite of the LH side.



4. REMOVE NO. 1 ULTRASONIC SENSOR RETAINER


    E134854
  1. Disengage the 2 claws and remove the No. 1 ultrasonic sensor retainer from the front bumper.

    HINT:
    The illustration is for the LH side. The RH side is the opposite of the LH side.