Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › ULTRASONIC SENSOR (for Rear Side)

ULTRASONIC SENSOR (for Rear Side) > REMOVAL

for Preparation Click here



1. REMOVE REAR QUARTER PANEL MUDGUARD SUB-ASSEMBLY LH


    B137209
  1. Remove the 3 screws and rear quarter panel mudguard sub-assembly LH.



2. REMOVE REAR QUARTER PANEL MUDGUARD SUB-ASSEMBLY RH

HINT:
Use the same procedure for the RH side and LH side.



3. REMOVE REAR BUMPER ASSEMBLY


    B137211E01
  1. Put protective tape around the rear bumper assembly.



    B137212
  1. Using a screwdriver, open the 2 rear bumper plates.

    HINT:
    Tape the screwdriver tip before use.



    B137214
  1. Remove the 6 screws and 2 clips.



    B137215
  1. Disengage the 12 claws and disconnect the rear bumper assembly as shown in the illustration.

    HINT:
    Use the same procedure for the RH side and LH side.



  1. w/ TOYOTA Parking Assist-sensor System:



      B224151
    1. Disconnect the connector.

  1. Remove the rear bumper assembly.



4. REMOVE NO. 1 ULTRASONIC SENSOR (for Back Sensor)
  1. Disconnect the sensor connector.



    E134860
  1. Remove the sensor clip as shown in the illustration.



    E134861
  1. While pushing down on the lever with a finger to release the claw, disengage the claw on the other side to remove the No. 1 ultrasonic sensor.

    HINT:
    The type of the claw on the top and bottom of the sensor are different. Observe the claws carefully before attempting to remove the sensor.



5. REMOVE NO. 1 ULTRASONIC SENSOR RETAINER (for Back Sensor)


    E134854
  1. Disengage the 2 claws and remove the No. 1 ultrasonic sensor retainer from the rear bumper.



6. REMOVE NO. 1 ULTRASONIC SENSOR (for Corner Sensor)
  1. Disconnect the sensor connector.



    E134853
  1. While pushing down on the lever with a finger to release the claw, disengage the claw on the other side to remove the No. 1 ultrasonic sensor.

    HINT:
    1. The type of the claw on the top and bottom of the sensor are different. Observe the claws carefully before attempting to remove the sensor.
    2. The illustration is for the LH side. The RH side is the opposite of the LH side.



7. REMOVE NO. 1 ULTRASONIC SENSOR RETAINER (for Corner Sensor)


    E134854
  1. Disengage the 2 claws and remove the No. 1 ultrasonic sensor retainer from the rear bumper.

    HINT:
    The illustration is for the LH side. The RH side is the opposite of the LH side.