Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › CLEARANCE WARNING BUZZER (for Back Sensor)

CLEARANCE WARNING BUZZER (for Back Sensor) > REMOVAL

for Preparation Click here



1. REMOVE FRONT DOOR SCUFF PLATE LH


    B132067
  1. Disengage the 7 claws and 3 clips, and remove the front door scuff plate LH.



2. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH


    B132116E01
  1. Remove the cowl side trim clip.

  1. Disengage the 2 clips and remove the cowl side trim sub-assembly LH.



3. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL LH


    B147263E01
  1. Remove the bolt <A> and the screw <B>.

  1. Disengage the 2 claws and the DLC3.

  1. Disconnect the hood lock control cable assembly.

  1. Disengage the claw and the 4 clips.

  1. Remove the air hose, disconnect the connector, and then remove the lower instrument panel finish panel LH.



4. REMOVE CLEARANCE WARNING BUZZER
  1. Disconnect the connector.



    E163881
  1. Disengage the clamp and remove the clearance warning buzzer.