HEADLIGHT ASSEMBLY > REMOVAL |
| 1. PRECAUTION (for HID Headlight) |
w/ Navigation System:
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (for HID Headlight) |
| 3. REMOVE COOL AIR INTAKE DUCT SEAL (for 2GR-FE) |
![]() |
Remove the 7 clips and cool air intake duct seal.
| 4. REMOVE FRONT BUMPER ASSEMBLY |
![]() |
Put protective tape around the front bumper assembly.
![]() |
Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.
![]() |
Remove the 8 screws, 2 clips, 2 radiator grille protectors and bolt.
![]() |
Disengage the 2 claws and disconnect the front bumper assembly as shown in the illustration.
Disconnect each connector.
w/ TOYOTA Parking Assist-sensor System:
Disengage the clamp and disconnect the No. 1 ultrasonic sensor connector.
w/ Headlight Cleaner System:
Disconnect the headlight cleaner washer hose.
![]() |
Remove the front bumper assembly.
| 5. REMOVE HEADLIGHT ASSEMBLY |
![]() |
Remove the bolt and 2 screws.
Disengage the clamp.
Disconnect each connector and remove the headlight assembly.