Home › BODY ELECTRICAL › LIGHTING › REAR COMBINATION LIGHT ASSEMBLY

REAR COMBINATION LIGHT ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL REAR LIGHT ASSEMBLY


    E128227E01
  1. Engage the clip and install the rear light assembly.

  1. Install the 3 nuts.

    Torque:
    3.6 N*m{ 37 kgf*cm , 32 in.*lbf }



    E128231E01
  1. Connect the connector and clamp.



2. INSTALL LUGGAGE COMPARTMENT DOOR COVER


    B135465
  1. Install the luggage compartment door cover with the 13 clips.



3. INSTALL LUGGAGE COMPARTMENT DOOR ASSIST GRIP (w/ Assist Grip)


    B189102
  1. Install the luggage compartment door assist grip with the 2 screws.



    B189103
  1. Engage the 3 claws and close the assist grip cover.



4. INSTALL REAR COMBINATION LIGHT ASSEMBLY


    E128229
  1. Engage the clip and install the rear combination light assembly.

  1. Install the 3 nuts.

    Torque:
    3.6 N*m{ 37 kgf*cm , 32 in.*lbf }



    E128226E01
  1. Connect the 2 connectors and clamp.



5. INSTALL REAR BUMPER ASSEMBLY


  1. w/ TOYOTA Parking Assist-sensor System:



      B224151
    1. Connect the connector.



    B227289
  1. Engage the 12 claws and connect the rear bumper assembly as shown in the illustration.

    HINT:
    Use the same procedure for the LH side and RH side.



    B137214
  1. Install the rear bumper assembly with the 6 screws and 2 clips.



    B137213
  1. Install the 2 rear bumper plates.



6. INSTALL REAR QUARTER PANEL MUDGUARD SUB-ASSEMBLY LH (w/ Rear Fender Mudguard)


    B137209
  1. Install the rear quarter panel mudguard sub-assembly LH with the 3 screws.



7. INSTALL REAR QUARTER PANEL MUDGUARD SUB-ASSEMBLY RH (w/ Rear Fender Mudguard)


8. INSTALL REAR FLOOR FINISH PLATE


    B136852
  1. Engage the 7 clips and install the rear floor finish plate.



9. INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK


    B136879
  1. Install the 2 No. 1 luggage compartment trim hooks with the 2 screws.



10. INSTALL LUGGAGE COMPARTMENT SIDE TRAY ASSEMBLY


    B136853
  1. Engage the clip and install the luggage compartment side tray assembly.

  1. Install the bolt.



11. INSTALL SPARE WHEEL COVER ASSEMBLY


12. INSTALL SPARE WHEEL COVER CLAMP


13. INSTALL LUGGAGE COMPARTMENT FLOOR MAT