Home › BODY ELECTRICAL › LIGHTING › REAR COMBINATION LIGHT ASSEMBLY

REAR COMBINATION LIGHT ASSEMBLY > REMOVAL

for Preparation Click here



1. REMOVE REAR QUARTER PANEL MUDGUARD SUB-ASSEMBLY LH (w/ Rear Fender Mudguard)


    B137209
  1. Remove the 3 screws and rear quarter panel mudguard sub-assembly LH.



2. REMOVE REAR QUARTER PANEL MUDGUARD SUB-ASSEMBLY RH (w/ Rear Fender Mudguard)


3. REMOVE REAR BUMPER ASSEMBLY


    B137211E01
  1. Put protective tape around the rear bumper assembly.



    B137212
  1. Using a screwdriver, open the 2 rear bumper plates.

    HINT:
    Tape the screwdriver tip before use.



    B137214
  1. Remove the 6 screws and 2 clips.



    B137215
  1. Disengage the 12 claws and disconnect the rear bumper assembly as shown in the illustration.

    HINT:
    Use the same procedures for the RH side and LH side.

  1. Remove the rear bumper assembly.



4. REMOVE LUGGAGE COMPARTMENT FLOOR MAT


5. REMOVE SPARE WHEEL COVER CLAMP


6. REMOVE SPARE WHEEL COVER ASSEMBLY


7. REMOVE LUGGAGE COMPARTMENT SIDE TRAY ASSEMBLY


    B136853
  1. Remove the bolt.

  1. Disengage the clip and remove the luggage compartment side tray assembly.



8. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK


    B136879
  1. Remove the 2 screws and the 2 No. 1 luggage compartment trim hooks.



9. REMOVE REAR FLOOR FINISH PLATE


    B136852
  1. Disengage the 7 clips and remove the rear floor finish plate.



10. REMOVE REAR COMBINATION LIGHT ASSEMBLY


    E128226E01
  1. Disconnect the 2 connectors and clamp.



    E128228
  1. Remove the 3 nuts.

  1. Disengage the clip and remove the rear combination light assembly.



11. REMOVE LUGGAGE COMPARTMENT DOOR COVER


    B135465
  1. Using a clip remover, remove the 13 clips and luggage compartment door cover.



12. REMOVE REAR LIGHT ASSEMBLY


    E128231E01
  1. Disconnect the connector and clamp.



    E128227E01
  1. Remove the 3 nuts.

  1. Disengage the clip and remove the rear light assembly.