Home › BODY ELECTRICAL › LIGHTING › REAR COMBINATION LIGHT ASSEMBLY

REAR COMBINATION LIGHT ASSEMBLY > DISASSEMBLY

for Preparation Click here



1. REMOVE REAR COMBINATION LIGHT GASKET


    E128217
  1. Remove the rear combination light gasket.

    NOTICE:
    1. Be sure to remove all traces of the old gasket from the body.
    2. Do not reuse the removed gasket. Be sure to install a new rear combination light gasket to prevent water ingress.



2. REMOVE TAIL AND STOP LIGHT BULB


    E128220
  1. Turn the tail and stop light bulb and the tail and stop light socket in the direction indicated by the arrow and disconnect them as a unit.

  1. Remove the tail and stop bulb from the tail and stop light socket.



3. REMOVE REAR TURN SIGNAL LIGHT BULB


    E128218
  1. Turn the rear turn signal light bulb and the rear turn signal light socket in the direction indicated by the arrow and disconnect them as a unit.

  1. Remove the rear turn signal light bulb from the rear turn signal light socket.



4. REMOVE REAR BUMPER RETAINER UPPER


    E130242
  1. Disengage the claw and remove the rear bumper retainer upper.



5. REMOVE BACK UP LIGHT BULB


    E128213
  1. Turn the back up light bulb and the rear light socket and wire in the direction indicated by the arrow and remove them as a unit.

  1. Remove the back up light bulb from the rear light socket and wire.



6. REMOVE TAIL LIGHT BULB (w/o Rear Fog Light)


    E130214
  1. Turn the tail light bulb and the rear light socket and wire in the direction indicated by the arrow and remove them as a unit.

  1. Remove the tail light bulb from the rear light socket and wire.



7. REMOVE REAR FOG LIGHT BULB (w/ Rear Fog Light)


    E128215
  1. Turn the rear fog light bulb and the rear light socket and wire in the direction indicated by the arrow and remove them as a unit.

  1. Remove the rear fog light bulb from the rear light socket and wire.



8. REMOVE REAR LIGHT GASKET


    E128212
  1. Remove the rear light gasket.

    NOTICE:
    1. Be sure to remove all traces of the old gasket from the body.
    2. Do not reuse the removed gasket. Be sure to install a new rear light gasket to prevent water ingress.