Home › BODY ELECTRICAL › LIGHTING › HEADLIGHT DIMMER SWITCH

HEADLIGHT DIMMER SWITCH > REMOVAL

for Preparation Click here



1. PRECAUTION
Be sure to read "PRECAUTION" thoroughly before servicing (Click here).


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait for 90 seconds after disconnecting the cable to prevent airbag deployment.



3. PLACE FRONT WHEELS FACING STRAIGHT AHEAD


4. REMOVE NO. 2 LOWER STEERING WHEEL COVER


    C141757
  1. Using a screwdriver, disengage the claw and remove the No. 2 lower steering wheel cover.

    HINT:
    Tape up the screwdriver tip before use.



5. REMOVE NO. 3 LOWER STEERING WHEEL COVER


    C141756
  1. Using a screwdriver, disengage the claw and remove the No. 3 lower steering wheel cover.

    HINT:
    Tape up the screwdriver tip before use.



6. REMOVE STEERING PAD


    C141758E02
  1. Using a "TORX" socket (T30), loosen the 2 "TORX" screws until the groove along the screw circumference catches on the screw case.



    C133859
  1. Pull out the steering pad from the steering wheel assembly and support the steering pad with one hand.

    NOTICE:
    When removing the steering pad, do not pull the airbag wire harness.

  1. Disconnect the horn connector from the steering pad.

  1. Disconnect the 2 airbag connectors and remove the steering pad.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Remove the steering pad.



7. REMOVE STEERING WHEEL ASSEMBLY
  1. Remove the steering wheel assembly set nut.

  1. Put matchmarks on the steering wheel assembly and the steering main shaft.

  1. Disconnect the connectors from the spiral cable.



    C132542E01
  1. Using SST, remove the steering wheel assembly.

    SST
    09950-50013   (09951-05010, 09952-05010, 09953-05020, 09954-05031)



8. REMOVE STEERING COLUMN COVER


    B137294E01
  1. Remove the 2 screws <D>.

  1. Disengage the 2 claws and remove the lower steering column cover.

  1. Disengage the claw and remove the upper steering column cover.



9. REMOVE SPIRAL CABLE WITH STEERING ANGLE SENSOR


    C133869
  1. Disconnect the connectors from the spiral cable with steering angle sensor.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Disengage the 3 claws and remove the spiral cable with steering angle sensor.



10. REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY


    E128824
  1. Disconnect the 2 connectors.

  1. Disengage the claw and remove the windshield wiper switch assembly as shown in the illustration.

    NOTICE:
    If the claw is pushed with excessive force, it may break.



11. REMOVE HEADLIGHT DIMMER SWITCH ASSEMBLY


    E128206E01
  1. Disconnect the connector.

  1. Disengage the clamp as shown in the illustration.



    E128208
  1. Disengage the claw and remove the headlight dimmer switch assembly as shown in the illustration.