Home › ENGINE ยท 2GR-FE › STARTING › STARTER

STARTER > DISASSEMBLY

for Preparation Click here



1. REMOVE REPAIR SERVICE STARTER KIT


    A079718E05
  1. Remove the nut and disconnect the lead wire from terminal C.



    A079719E05
  1. Remove the 2 screws that hold the magnetic switch to the motor terminal starter kit.

  1. Remove the repair service starter kit.

  1. Remove the return spring and the plunger from the repair service starter kit.



2. REMOVE STARTER YOKE ASSEMBLY


    A079720E05
  1. Remove the 2 through bolts and pull out the starter yoke assembly together with the starter commutator end frame assembly.



    A079721E03
  1. Remove the starter yoke assembly from the starter commutator end frame assembly.



3. REMOVE STARTER ARMATURE PLATE


    A079722E04
  1. Remove the starter armature plate from the starter yoke assembly.



4. REMOVE STARTER COMMUTATOR END FRAME COVER


    A079723E03
  1. Using a screwdriver, remove the starter commutator end frame cover.



5. REMOVE STARTER ARMATURE ASSEMBLY


    A082440E07
  1. Using snap ring pliers, remove the snap ring and plate washer.

  1. Remove the starter armature assembly from the commutator end frame assembly.



6. REMOVE PLANETARY GEAR


    A081167E03
  1. Remove the 3 planetary gears from the motor terminal starter kit.