WIRELESS DOOR LOCK CONTROL SYSTEM (w/ Entry and Start System) > TERMINALS OF ECU |
| CHECK MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY) |
Disconnect the main body ECU (instrument panel junction block assembly) connectors.

Measure the resistance and voltage between each terminal of the wire harness side connectors and body ground.
| Symbols (Terminal No.) | Wiring Color | Terminal Description | Condition | Specified Condition |
| E6-7 (RCTY) - Body ground | GR - Body ground | Rear courtesy light switch RH input | Rear door RH CLOSED (OFF) → OPEN (ON) | 10 kΩ or higher → Below 1 Ω |
| E6-21 (PCTY) - Body ground | Y - Body ground*1 | Passenger side courtesy light switch input | Passenger side door CLOSED (OFF) → OPEN (ON) | 10 kΩ or higher → Below 1 Ω |
| L - Body ground*2 | ||||
| E7-24 (DCTY) - Body ground | L - Body ground*1 | Driver side door courtesy light switch input | Driver side door CLOSED (OFF) → OPEN (ON) | 10 kΩ or higher → Below 1 Ω |
| Y - Body ground*2 | ||||
| IA-1 (ACC) - Body ground | B - Body ground | Ignition power supply (ACC signal) | Engine switch on (ACC) → off | 10 to 14 V → Below 1 V |
| IA-1 (IG) - Body ground | B - Body ground | Ignition power supply (IG signal) | Engine switch on (IG) → off | 10 to 14 V → Below 1 V |
| ID-16 (ALTB) - Body ground | W - Body ground | +B (power system alternator system) power supply | Always | 10 to 14 V |
| IF-10 (GND1) - Body ground | W-B - Body ground | Ground | Always | Below 1 Ω |
| IM-9 (GND2) - Body ground | W-B - Body ground | Ground | Always | Below 1 Ω |
| IO-7 (LCTY) - Body ground | LG - Body ground | Rear courtesy light switch LH input | Rear door LH CLOSED (OFF) → OPEN (ON) | 10 kΩ or higher → Below 1 Ω |
Reconnect the main body ECU (instrument panel Junction block) connectors.
Measure the voltage between each terminal of the wire harness side connectors and body ground.
| Symbols (Terminal No.) | Wiring Color | Terminal Description | Condition | Specified Condition |
| E8-4 (HAZ) - Body ground | W - Body ground | Turn signal flasher relay signal | Any transmitter switch is pressed → not pressed | Below 1 V* → 11 to 14 V |
| CHECK CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) |

Disconnect the E74 ECU connector.
Measure the resistance and voltage according to the value(s) in the table below.
| Terminal No. (Symbols) | Wiring Color | Terminal Description | Condition | Specified Condition |
| E74-17 (E) - Body ground | W-B - Body ground | Ground | Always | Below 1 Ω |
| E74-1 (+B) - E74-17 (E) | W - W-B | Battery power supply | Always | 11 to 14 V |
| E74-18 (IG) - E74-17 (E) | LG - W-B | IG power supply | Engine switch on (IG) | 11 to 14 V |
| Engine switch off | Below 1 V |
Reconnect the E74 ECU connector.
Measure the voltage according to the value(s) in the table below.
| Terminal No. (Symbols) | Wiring Color | Terminal Description | Condition | Specified Condition |
| E74-39 (RSSI) - E74-17 (E) | R - W-B | Door control receiver output signal | Engine switch off, all doors closed and transmitter switch not pressed | 11 to 14 V |
| Engine switch off, all doors closed and transmitter switch pressed | Below 1 V | |||
| E74-38 (RDA) - E74-17 (E) | Y - W-B | Door control receiver output signal | Engine switch off | Pulse generation (11 to 14 V) |
| E74-29 (RC0) - E74-17 (E) | G - W-B | Supply battery to door control receiver | Engine switch off, all doors closed and transmitter switch pressed | 4.6 to 5.4 V |
| E74-21 (BZR) - Body ground | BE - Body ground | Wireless door lock buzzer signal | Wireless door lock buzzer OFF → ON | Below 1 V → Pulse generation |