Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › CLUTCH SWITCH

CLUTCH SWITCH > REMOVAL

for Preparation Click here



1. REMOVE FRONT DOOR SCUFF PLATE LH (for LHD)


    B132067
  1. Disengage the 7 claws and 3 clips, and remove the front door scuff plate LH.



2. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH (for LHD)


    B132116E01
  1. Remove the cowl side trim clip.

  1. Disengage the 2 clips and remove the cowl side trim sub-assembly LH.



3. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL LH (for LHD)


    B147263E01
  1. Remove the bolt <A> and the screw <B>.

  1. Disengage the 2 claws and the DLC3.

  1. Disconnect the hood lock control cable assembly.

  1. Disengage the claw and the 4 clips.

  1. Remove the air hose, disconnect the connector, and then remove the lower instrument panel finish panel LH.



4. REMOVE MAIN BODY ECU (COWL SIDE JUNCTION BLOCK LH) (for LHD)
  1. Disconnect all connectors.



    E128298
  1. Remove the 2 nuts and the main body ECU (cowl side junction block LH).



5. REMOVE FRONT DOOR SCUFF PLATE RH (for RHD)

HINT:
Use the same procedures for the RH side and the LH side.



6. REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH (for RHD)

HINT:
Use the same procedures for the RH side and the LH side.



7. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL RH (for RHD)


8. REMOVE CLUTCH SWITCH ASSEMBLY
  1. Disconnect the connector.



    E131698E01
  1. Loosen the nut and remove the clutch switch assembly.