CLUTCH SWITCH > REMOVAL |
| 1. REMOVE FRONT DOOR SCUFF PLATE LH (for LHD) |
![]() |
Disengage the 7 claws and 3 clips, and remove the front door scuff plate LH.
| 2. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH (for LHD) |
![]() |
Remove the cowl side trim clip.
Disengage the 2 clips and remove the cowl side trim sub-assembly LH.
| 3. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL LH (for LHD) |
![]() |
Remove the bolt <A> and the screw <B>.
Disengage the 2 claws and the DLC3.
Disconnect the hood lock control cable assembly.
Disengage the claw and the 4 clips.
Remove the air hose, disconnect the connector, and then remove the lower instrument panel finish panel LH.
| 4. REMOVE MAIN BODY ECU (COWL SIDE JUNCTION BLOCK LH) (for LHD) |
Disconnect all connectors.
![]() |
Remove the 2 nuts and the main body ECU (cowl side junction block LH).
| 5. REMOVE FRONT DOOR SCUFF PLATE RH (for RHD) |
| 6. REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH (for RHD) |
| 7. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL RH (for RHD) |
| 8. REMOVE CLUTCH SWITCH ASSEMBLY |
Disconnect the connector.
![]() |
Loosen the nut and remove the clutch switch assembly.