IGNITION SYSTEM > ON-VEHICLE INSPECTION |
| 1. CHECK IGNITION COIL ASSEMBLY AND PERFORM SPARK TEST |
Check for DTCs.
Check that sparks occur.
Remove the No. 1 engine cover.
Disconnect the 4 ignition coil connectors and remove the 4 bolts and ignition coils.
![]() |
Using a 16 mm (0.63 in.) spark plug wrench, remove the 4 spark plugs.
![]() |
Disconnect the 4 fuel injector connectors.
Install the spark plug to each ignition coil, and connect the ignition coil connectors.
![]() |
Ground the spark plug.
Check if a spark occurs at each spark plug while the engine is being cranked.
Perform the spark test according to the flowchart below.
Check that the ignition coil connector is securely connected.
| Result | Proceed to |
| NG | Connect securely |
| OK | Go to next step |
Perform the spark test on each ignition coil.
| Result | Proceed to |
| OK | Replace ignition coil |
| NG | Go to next step |
![]() |
Check the power supply to the ignition coil.
| Tester Connection | Specified Condition |
| 1 (+B) - 4 (GND) | 9 to 14 V |
| Result | Proceed to |
| NG | Check wire harness and connector |
| OK | Go to next step |
Measure the resistance of the camshaft position sensor.
| Temperature | Specified Condition |
| Cold | 835 to 1,400 Ω |
| Hot | 1,060 to 1,645 Ω |
| Result | Proceed to |
| NG | Replace camshaft position sensor |
| OK | Go to next step |
Measure the resistance of the crankshaft position sensor.
| Temperature | Specified Condition |
| Cold | 985 to 1,600 Ω |
| Hot | 1,265 to 1,890 Ω |
| Result | Proceed to |
| NG | Replace crankshaft position sensor |
| OK | Go to next step |
Check the IGT signal from the ECM.
| Result | Proceed to |
| NG | Check ECM (Click here) |
| OK | Repair wiring between ignition coil and ECM |
Using a 16 mm (0.63 in.) plug wrench, install the spark plug.
Install the 4 ignition coils with the 4 bolts and connect the 4 ignition coil connectors.
Connect the 4 fuel injector connectors.
Install the No. 1 engine cover.
| 2. CHECK SPARK PLUG |
![]() |
Check the electrode.
Using a megohmmeter, measure the insulation resistance.
![]() |
Alternative inspection method:
Quickly accelerate the engine to 4,000 rpm 5 times.
Remove the spark plug.
Visually check the spark plug.
If the electrode is dry, the spark plug is functioning properly. If the electrode is damp, proceed to the next step.
Check the spark plug for any damage to its threads and insulator.
If there is damage, replace the spark plug.
| Manufacturer | Spark plug type |
| DENSO | SK20R11 |
| NGK | IFR6A11 |
![]() |
Check the spark plug electrode gap.
![]() |
Clean the spark plugs.
If the electrode has traces of wet carbon, clean the electrode with a spark plug cleaner and then dry it.