OIL PUMP > INSPECTION |
| 1. INSPECT OIL JET |
![]() |
Check the oil jet for damage or clogging.
If necessary, repair the cylinder block.
| 2. INSPECT OIL PUMP RELIEF VALVE |
![]() |
Check the relief valve.
Coat the valve with engine oil, and then check that the valve falls smoothly into the valve hole under its own weight.
If the valve does not fall smoothly, replace the relief valve. If necessary, replace the oil pump assembly.
| 3. INSPECT OIL PUMP ROTOR |
Install the oil pump rotor.
![]() |
Coat the drive rotor and driven rotor with engine oil.
Place the drive and driven rotors into the oil pump with the marks facing the pump cover side.
![]() |
Check the side clearance.
Using a feeler gauge and precision straightedge, measure the clearance between the rotors and precision straightedge.
![]() |
Check the tip clearance.
Using a feeler gauge, measure the clearance between the drive and driven rotor tips.
![]() |
Check the body clearance.
Using a feeler gauge, measure the clearance between the driven rotor and pump body.
| 4. INSPECT NO. 2 CHAIN SUB-ASSEMBLY |
![]() |
Pull the chain with a force of 140 N (14.3 kgf, 31.5 lbf) as shown in the illustration.
Using vernier calipers, measure the length of 15 links.
| 5. INSPECT OIL PUMP DRIVE SPROCKET |
![]() |
Wrap the chain around the sprocket.
Using vernier calipers, measure the sprocket diameter with the chain wrapped around.
| 6. INSPECT OIL PUMP DRIVEN SPROCKET |
![]() |
Wrap the chain around the sprocket.
Using vernier calipers, measure the sprocket diameter with the chain wrapped around.
| 7. INSPECT CHAIN TENSIONER PLATE |
![]() |
Using vernier calipers, measure the vibration damper wear.