Home › ENGINE ยท 2AZ-FE › LUBRICATION › ENGINE OIL COOLER

ENGINE OIL COOLER > REMOVAL

for Preparation Click here



1. REMOVE ENGINE UNDER COVER RH


2. REMOVE ENGINE UNDER COVER LH


3. DRAIN ENGINE COOLANT

NOTICE:
Do not remove the radiator cap sub-assembly while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

  1. Remove the radiator cap sub-assembly from the radiator assembly.



  1. Loosen the radiator drain cock plug and cylinder block drain cock plug, then drain the coolant.


    A136224E04

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.



4. DRAIN ENGINE OIL
  1. Remove the oil filler cap.

  1. Remove the oil drain plug and drain the oil into a container.



5. REMOVE OIL FILTER SUB-ASSEMBLY


    A136225E01
  1. Using SST, remove the oil filter.

    SST
    09228-06501  



6. REMOVE ENGINE OIL COOLER


    A114329
  1. Disconnect the 2 oil cooler hoses from the oil cooler.

  1. Remove the oil cooler union bolt, plate washer, nut, oil cooler and O-ring.