POWER STEERING LINK > REMOVAL |
| 1. PLACE FRONT WHEELS FACING STRAIGHT AHEAD |
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 3. REMOVE FRONT WHEELS |
| 4. SEPARATE STEERING SLIDING YOKE |
![]() |
Secure the steering wheel with the seat belt in order to prevent rotation.
![]() |
Remove the bolt and slide the steering sliding yoke.
![]() |
Put matchmarks on the steering sliding yoke and the power steering link assembly.
Separate the steering sliding yoke from the power steering link assembly.
| 5. SEPARATE TIE ROD ASSEMBLY LH |
Remove the cotter pin and the nut.
![]() |
Using SST, separate the tie rod assembly LH from the steering knuckle.
| 6. SEPARATE TIE ROD ASSEMBLY RH |
| 7. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE |
| 8. DISCONNECT PRESSURE FEED TUBE ASSEMBLY (for LHD) |
![]() |
Using SST, disconnect the pressure feed tube assembly (return tube side) from the power steering link assembly.
![]() |
Using SST, disconnect the pressure feed tube assembly (pressure feed tube side) from the power steering link assembly.
![]() |
Remove the 2 bolts and separate the pressure feed tube clamp.
| 9. DISCONNECT STEERING GEAR OUTLET RETURN TUBE (for 2AZ-FE RHD) |
![]() |
Slide the clip and disconnect the steering gear outlet return tube.
| 10. REMOVE RETURN TUBE ASSEMBLY (for 2AZ-FE RHD) |
![]() |
Using SST, remove the return tube assembly from the power steering link assembly.
| 11. DISCONNECT PRESSURE FEED TUBE ASSEMBLY (for 2AZ-FE RHD) |
![]() |
Using SST, disconnect the pressure feed tube assembly from the power steering link assembly.
![]() |
Remove the bolt and separate the pressure feed tube clamp.
| 12. DISCONNECT STEERING GEAR OUTLET RETURN TUBE (for 2GR-FE RHD) |
![]() |
Slide the clip and disconnect the steering gear outlet return tube.
| 13. REMOVE RETURN TUBE ASSEMBLY (for 2GR-FE RHD) |
![]() |
Using SST, remove the return tube assembly from the power steering link assembly.
| 14. DISCONNECT PRESSURE FEED TUBE ASSEMBLY (for 2GR-FE RHD) |
![]() |
Using SST, disconnect the pressure feed tube assembly from the power steering link assembly.
![]() |
Remove the bolt and separate the pressure feed tube clamp.
| 15. REMOVE POWER STEERING LINK ASSEMBLY |
![]() |
Remove the 2 bolts, 2 nuts, and the power steering link assembly.
| 16. REMOVE POWER STEERING RACK HOUSING HEAT INSULATOR (for 2GR-FE LHD) |
![]() |
Remove the power steering rack housing heat insulator from the power steering link assembly.
| 17. REMOVE POWER STEERING RACK HOUSING HEAT INSULATOR (for 2GR-FE RHD) |
![]() |
Remove the bolt and power steering rack housing heat insulator from the power steering link assembly.