LIGHTING SYSTEM > Interior Light Circuit |

| 1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position and turn the intelligent tester main switch on.
Select the item(s) below in the ACTIVE TEST, and check the operation.
| Item | Test Details | Diagnostic Note |
| INTERIOR LAMP | Interior light and ignition key cylinder light ON / OFF (Interior light switch is in DOOR position and all doors are closed). | - |
|
| ||||
| NG | |
| 2.CHECK VEHICLE CONDITION |
Check the vehicle condition.
| Condition | Proceed to |
| without Sliding Roof | A |
| with Sliding Roof | B |
|
| ||||
| A | |
| 3.CHECK HARNESS AND CONNECTOR (LIGHT - BATTERY AND INSTRUMENT PANEL J/B ASSEMBLY) |
![]() |
Disconnect the E25 transponder key amplifier connector.
Disconnect the Q9 rear room light assembly connector.
Disconnect the IR and II instrument panel J/B assembly connectors.
Measure the voltage and resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E25-2 - Body ground | Always | 10 to 14 V |
| Q9-1 - Body ground | Always | 10 to 14 V |
| Tester Connection | Condition | Specified Condition |
| II-10 - E25-6 | Always | Below 1 Ω |
| IR-5 - Q9-2 | Always | Below 1 Ω |
| II-10 - Body ground | Always | 10 kΩ or higher |
| IR-5 - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||
| 4.CHECK HARNESS AND CONNECTOR (LIGHT - BATTERY AND INSTRUMENT PANEL J/B ASSEMBLY) |
![]() |
Disconnect the E25 transponder key amplifier connector.
Disconnect the Q6 overhead J/B connector.
Disconnect the IR and II instrument panel J/B assembly connectors.
Measure the voltage and resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E25-2 - Body ground | Always | 10 to 14 V |
| Q6-7 - Body ground | Always | 10 to 14 V |
| Tester Connection | Condition | Specified Condition |
| II-10 - E25-6 | Always | Below 1 Ω |
| IR-5 - Q6-6 | Always | Below 1 Ω |
| II-10 - Body ground | Always | 10 kΩ or higher |
| IR-5 - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||