LIGHTING SYSTEM > Headlight Beam Level Warning Circuit |

| 1.INSPECT COMBINATION METER ASSEMBLY |
![]() |
Remove the combination meter assembly.
Apply battery voltage to the combination meter assembly connector.
Check that the warning light comes on.
| Measurement Condition | Specified Condition |
| Battery positive (+) → Terminal F1-13 (IG+) Battery negative (-) → Terminal F2-5 (LVWG) | Warning light comes on. |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (BATTERY - COMBINATION METER ASSEMBLY) |
![]() |
Disconnect the F1 combination meter assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| F1-13 (IG+) - Body ground | Ignition switch ON | 10 to 14 V |
| Ignition switch OFF | Below 1 V |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - ECU) |
![]() |
Disconnect the F2 combination meter assembly connector.
Disconnect the A20 headlight beam level control ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A20-6 (WNG) - F2-5 (LVWG) | Always | Below 1 Ω |
| A20-6 (WNG) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||